ASTM F2263-2007e1 评定聚乙烯管(PE)抗氯化水氧化性的标准试验方法

sigh007

                   【英文标准名称】:     Standard Test Method for Evaluating the Oxidative Resistance of Polyethylene (PE) Pipe to Chlorinated Water            【原文标准名称】:     评定聚乙烯管(PE)抗氯化水氧化性的标准试验方法            【标准号】:     ASTM F2263-2007e1            【标准状态】:     现行            【国别】:                 【发布日期】:     2007    【实施或试行日期】: 【发布单位】: 美国材料与试验协会(US-ASTM)【起草单位】: F17.40【标准类型】: (Test Method)【标准水平】: ()【中文主题词】: 氯化的;评定;聚乙烯;管;抵抗;水【英文主题词】: chlorine resistance;  oxidative resistance;  pipe;  polyethylene【摘要】: 1.1 This test method describes the general requirements for evaluating the long-term, chlorinated water, oxidative resistance of polyethylene (PE), used in cold water supply or service systems by exposure to chlorinated water. This test method outlines the requirements of a pressurized flow-through test system, typical test pressures, test-fluid characteristics, failure type, and data analysis.Note 1Other known disinfecting systems (chlorine dioxide, ozone, and chloramine) are currently used for protection of potable water; however, free-chlorine is by far the most common system in use today. Disinfecting systems other than chlorine have not been evaluated by this method.1.2 Guidelines and requirements for test temperatures, test hoop stresses, and other test criteria have been established by prior testing of PE pipe. Other related system components that typically appear in a PE cold water supply or service system can be evaluated with the PE pipe. When testing PE pipe and fittings as a system, it is recommended that the anticipated end-use fitting type(s) and material(s) be included in the test circuit since it is known that some fitting types and materials can impact failure times. Specimens used shall be representative of the piping product(s) and material(s) under investigation.Note 2The procedures described in this test method (with some modifications of test temperatures or stresses, or both) have been used to evaluate pipes manufactured from polybutylene (PB), crosslinked polyethylene (PEX), polypropylene (PP), multilayer (polymer-metal composite), copper, and stainless steel.1.3 This test method is applicable to PE pipe and systems used for transport of potable water containing free-chlorine for disinfecting purposes. The oxidizing potential of the test-fluid specified in this test method exceeds that typically found in potable water systems across the United States.1.4 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are for information only and are not considered standard.The following precautionary caveat pertains only to the test method portion, Section , of this specification.This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.【中国标准分类号】: G33【国际标准分类号】: 23_040_20【页数】: 6P.;A4【正文语种】:           
         

漫步者

请勿做单纯的伸手党。