ANSI/ASTM E108-2006 屋顶覆盖物着火试验方法

sigh007

                   【英文标准名称】:     Test Methods For Fire Tests Of Roof Coverings            【原文标准名称】:     屋顶覆盖物着火试验方法            【标准号】:     ANSI/ASTM E108-2006            【标准状态】:     作废            【国别】:     美国            【发布日期】:     2006    【实施或试行日期】: 2006-12-26【发布单位】: 美国国家标准学会(US-ANSI)【起草单位】: ANSI【标准类型】: ()【标准水平】: ()【中文主题词】: 屋顶层;火焰表面传播;试验;建筑;施工材料;建设工程;防火安全;建筑物防火;燃烧试验;屋面油毡;屋顶【英文主题词】: Construction;Construction materials;Construction works;Fire safety;Fire safety in buildings;Fire tests;Roof coverings;Roofing felts;Roofs;Surface spread of flame;Testing【摘要】: This fire-test-response standard covers the measurement of the relative fire characteristics of roof coverings under simulated fire originating outside the building. It is applicable to roof coverings intended for installation on either combustible or noncombustible decks when applied as intended for use. The following test methods are included:  Intermittent flame exposure test.  Spread of flame test.   Burning brand test.   Flying brand test.  Rain test.  Three classes of fire test exposure are described:  Class A Tests are applicable to roof coverings that are effective against severe test exposure, afford a high degree of fire protection to the roof deck, do not slip from position, and do not present a flying brand hazard.   Class B Tests are applicable to roof coverings that are effective against moderate test exposure, afford a moderate degree of fire protection to the roof deck, do not slip from position, and do not present a flying brand hazard.   Class C Tests are applicable to roof coverings that are effective against light test exposure, afford a light degree of fire protection to the roof deck, do not slip from position, and do not present a flying brand hazard.   The values stated in inch-pound units shall be regarded as the standard. Values given in brackets are for information only.  This standard is used to measure and describe the response of materials, products, or assemblies to heat and flame under controlled laboratory conditions, but does not by itself incorporate all factors required for fire hazard or fire risk assessment of the materials, products or assemblies under actual fire conditions. This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.  The text of this standard references notes and footnotes that provide explanatory information. These notes and footnotes, excluding those in tables and figures, shall not be considered as requirements of this standard.【中国标准分类号】: P16【国际标准分类号】: 13_220_50;91_060_20【页数】: 【正文语种】: 英语