ASTM D2463-2010b 吹塑热固塑料容器耐坠落冲击性的试验方法

sigh007

中文名称: 吹塑热固塑料容器耐坠落冲击性的试验方法

英文名称:Standard Test Method for Drop Impact Resistance of Blow-Molded Thermoplastic Containers

            
            
                          

中标分类：A82	ICS分类：83.080.20
标准分类编号：AS	页数：6

            
            
                          

发布日期：	实施日期：	作废日期：
被替代标准：		代替标准：ASTM D2463-2010a
引用标准：ASTM B177;ASTM E691BI-4		采用标准：
起草单位：		归口单位：

            
            
                          

标引依据：

补充修订：

备注：

范围：1.1 This test method provides measures of the drop impact resistance of blow-molded thermoplastic containers as a summation of the effects of material, manufacturing conditions, container design, and perhaps other factors. 1.2 Three procedures are provided as follows: 1.2.1 Procedure A, Static Drop Height Method—This procedure is particularly useful for quality control since it is quick. 1.2.2 Procedure B, Bruceton Staircase Method—This procedure is used to determine the mean failure height and the standard deviation of the distribution. 1.3 The values stated in SI units are to be regarded as standard. The inch-pound units given in parentheses are for information only.   Note 1—There is no known ISO equivalent to this standard.  1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicabili

下载地址:

dragonfly

大侠，请啊！！我找 ASTM D 2463这份标准好久了。

a111111111

谢谢分享！！！！！！！！！！！！

james72878

感謝分享工作剛好用到