ISO 20904-2006 硬煤.泥浆取样

sigh007

                   【英文标准名称】:     Hard coal - Sampling of slurries            【原文标准名称】:     硬煤.泥浆取样            【标准号】:     ISO 20904-2006            【标准状态】:     现行            【国别】:     国际            【发布日期】:     2006-10    【实施或试行日期】: 【发布单位】: 国际标准化组织(IX-ISO)【起草单位】: ISO/TC 27【标准类型】: ()【标准水平】: ()【中文主题词】: 烟煤;煤;焦炭;矿物燃料;燃料;取样;抽样方法;泥浆;固体燃料;规范(验收)【英文主题词】: Bituminous coal;Coal;Coke;Fossil fuels;Fuels;Hard coal;Material stream;Sampling;Sampling methods;Slurries;Solid fuels;Specification (approval)【摘要】: This International Standard sets out the basic methods for sampling fine coal, coal rejects or tailings of nominal top size < 4 mm that is mixed with water to form a slurry. At very high ratios of fine solids to water when the material assumes a soft plastic form, the mixture is correctly termed a paste. Sampling of pastes is not covered in this International Standard.The procedures described in this International Standard primarily apply to sampling of coal that is transported in moving streams as a slurry. These streams can fall freely or be confined in pipes, launders, chutes, spirals or similar channels. Sampling of slurries in stationary situations, such as a settled or even a well-stirred slurry in a tank, holding vessel or dam, is not recommended and is not covered in this International Standard.This International Standard describes procedures that are designed to provide samples representative of the slurry solids and particle size distribution of the slurry under examination. After draining the slurry sample of fluid and measuring the fluid volume, damp samples of the contained solids in the slurry are available for drying (if required) and measurement of one or more characteristics in an unbiased manner and with a known degree of precision. The characteristics are measured by chemical analysis or physical testing or both.The sampling methods described are applicable to slurries that require inspection to verify compliance with product specifications, determination of the value of a characteristic as a basis for settlement between trading partners or estimation of a set of average characteristics and variances that describes a system or procedure.Provided flow rates are not too high, the reference method against which other sampling procedures are compared is one where the entire stream is diverted into a vessel for a specified time or volume interval. This method corresponds to the stopped-belt method described in ISO 13909-2.【中国标准分类号】: D21【国际标准分类号】: 73_040【页数】: 35P.;A4【正文语种】: 英语