BS EN 60424-5-2009 铁氧体磁芯.表面缺陷的限值指南.第5部分:平面磁芯

sigh007

                   【英文标准名称】:     Ferrite cores - Guide on the limits of surface irregularities - Part 5lanar-cores            【原文标准名称】:     铁氧体磁芯.表面缺陷的限值指南.第5部分:平面磁芯            【标准号】:     BS EN 60424-5-2009            【标准状态】:     现行            【国别】:     英国            【发布日期】:     2009-07-31    【实施或试行日期】: 2009-07-31【发布单位】: 英国标准学会(GB-BSI)【起草单位】: BSI【标准类型】: ()【标准水平】: ()【中文主题词】: 裂纹;损伤;缺陷;E形铁芯;EI-铁芯;电气工程;铁氧体磁心;精整;瑕疵;指导手册;不完整性;铁芯;不规则性;极限(数学);磁的;电磁元件;磁学;分规范;规范;表面不连续性;外观检查(测试)【英文主题词】: Crack;Damage;Defects;E-cores;EI-cores;Electrical engineering;Ferrit cores;Finishes;Flaws;Guide books;Imperfections;Iron core;Irregularities;Limits (mathematics);Magnetic;Magnetic components;Magnetism;Sectional specification;Specification;Surface discontinuities;Visual inspection (testing)【摘要】: This part of IEC 60424 gives guidance on allowable limits of surface irregularities applicable to planar-cores in accordance with the relevant generic specification defined in IEC 60424-1.The relations between the main dimensions of planar E-, ER- and EL-cores differ from those of standard cores. For example, the width of planar cores is larger while the total height is much smaller. Also the thickness of the legs is in most cases smaller than compared to standard cores. Therefore the concept of fixed reference dimensions to determine the length of crack limits yield crack lengths which are not acceptable for this type of core. This part of IEC 60424 follows another concept which relates the crack length to dimensions of the surface on which the crack occurs.Also the concept to determine the maximum area of chips based on the total mating surface fails in the case of planar cores. The outer legs of planar cores are much thinner than those of standard cores which makes overlapping and gluing much more difficult. A single chip of maximum size on the outer leg may risk the functionality of the core set. Therefore this standard uses as a reference the mating surface on which the chip occurs.Windings of planar cores are often PCB’s which are glued to the inner surfaces of the planar core. For this reason the inner surfaces of the planar cores need to have a better quality than the inner surfaces of standard cores. This was taken into account by reducing the maximum allowable area of pull outs in the inner surfaces.This standard is considered as a sectional specification useful in the negotiation betweenferrite core manufacturers and users about surface irregularities.【中国标准分类号】: K14【国际标准分类号】: 29_100_10【页数】: 22P.;A4【正文语种】: 英语         
         

green_ch

where is the document? do you really have it?