ASTM D1275-2006 电绝缘油中腐蚀性硫的试验方法 下载

sigh007

中文名称: 电绝缘油中腐蚀性硫的试验方法

英文名称:STANDARD TEST METHOD FOR CORROSIVE SULFUR IN ELECTRICAL INSULATING OILS

            
            
                          

中标分类：K15	ICS分类：29.040.10
标准分类编号：AS	页数：3

            
            
                          

发布日期：	实施日期：2006-03-01	作废日期：
被替代标准：		代替标准：
引用标准：ANSI B74.10;ASTM D130		采用标准：
起草单位：		归口单位：

            
            
                          

标引依据：

补充修订：

备注：

范围：1.1 This test method describes the detection of corrosive sulfur compounds (both inorganic and organic) in electrical insulating oils of petroleum origin.1.2 New and in-service mineral insulating oils may contain substances that cause corrosion under certain conditions of use. This test method is designed to detect the presence of, or the propensity to form, free (elemental) sulfur and corrosive sulfur compounds by subjecting copper to contact with oil under prescribed conditions.1.3 Two methods (A and B) have been introduced where historically there has only been one. Method A is the one that has been in place since 1953. Method B is more rigorous and the preferred method.1.4 The values stated in SI units are to be regarded as the standard. Inch-pound units are included for informational purposes.This standard does not purport to address the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and healt 下载：

            

         
         

a280221580

谢谢分享！！！！！！！！！！！