ISO 8422-2006 计数检验的序贯抽样方案

sigh007

                   【英文标准名称】:     Sequential sampling plans for inspection by attributes            【原文标准名称】:     计数检验的序贯抽样方案            【标准号】:     ISO 8422-2006            【标准状态】:     现行            【国别】:     国际            【发布日期】:     2006-10    【实施或试行日期】: 【发布单位】: 国际标准化组织(IX-ISO)【起草单位】: ISO/TC 69【标准类型】: ()【标准水平】: ()【中文主题词】: 定义;计数检查;质量控制;样品试验;取样;抽样方法;抽样表;统计方法分析;统计学【英文主题词】: Definitions;Inspection by attributes;Quality control;Sample tests;Sampling;Sampling methods;Sampling tables;Statistical methods of analysis;Statistics【摘要】: This International Standard specifies sequential sampling plans and procedures for inspection by attributes ofdiscrete items.The plans are indexed in terms of the producer's risk point and the consumer's risk point. Therefore, they canbe used not only for the purposes of acceptance sampling, but for a more general purpose of the verificationof simple statistical hypotheses for proportions.The purpose of this International Standard is to provide procedures for sequential assessment of inspectionresults that may be used to induce the supplier, through the economic and psychological pressure of nonacceptanceof lots of inferior quality, to supply lots of a quality having a high probability of acceptance. At thesame time, the consumer is protected by a prescribed upper limit to the probability of accepting lots of poorquality.This International Standard provides sampling plans that are applicable, but not limited, to inspection indifferent fields, such as:- end items,- components and raw materials,- operations,- materials in process,- supplies in storage,- maintenance operations,- data or records, and- administrative procedures.This International Standard contains sampling plans for inspection by attributes of discrete items. Thesampling plans may be used when the extent of nonconformity is expressed either in terms of proportion (orpercent) nonconforming items or in terms of nonconformities per item (per 100 items).The sampling plans are based on the assumption that nonconformities occur randomly and with statisticalindependence. There may be good reasons to suspect that one nonconformity in an item could be caused bya condition also likely to cause others. If so, it would be better to consider the items just as conforming or not,and ignore multiple nonconformities.The sampling plans from this International Standard should primarily be used for the analysis of samplestaken from processes. For example, they may be used for the acceptance sampling of lots taken from aprocess that is under statistical control. However, they may also be used for the acceptance sampling of anisolated lot when its size is large, and the expected fraction nonconforming is small (significantly smaller than10 %).In the case of the acceptance sampling of continuing series of lots, the system of sequential sampling plansindexed by acceptance quality limit (AQL) for lot-by-lot inspection published in ISO 2859-5 should be applied.【中国标准分类号】: A00【国际标准分类号】: 03_120_30【页数】: 32P;A4【正文语种】: 英语         
         

流星雨

我想要下载请问怎么下载

a1314008888

流星雨 发表于 2014-8-14 13:16
我想要下载请问怎么下载

ISO 8422ISO 8422ISO 8422ISO 8422ISO 8422