ASTM D3466-2006 颗粒活性炭着火温度的试验方法 下载

sigh007

中文名称: 颗粒活性炭着火温度的试验方法

英文名称:Standard Test Method for Ignition Temperature of Granular Activated Carbon

            
            
                          

中标分类：G13	ICS分类：71.040.30
标准分类编号：AS	页数：4

            
            
                          

发布日期：	实施日期：2006-04-01	作废日期：
被替代标准：		代替标准：
引用标准：ASTM D2652;ASTM D2854;ASTM D3195;ASTM E11;ASTM E220;ASTM E300		采用标准：
起草单位：		归口单位：

            
            
                          

标引依据： ;

补充修订：

备注：

范围：1.1 This test method covers the determination of reference ignition temperature of granular activated carbon in flowing air. This test method provides a basis for comparing the ignition characteristics of different carbons, or the change in ignition characteristics of the same carbon after a period of service. 1.2 The ignition temperature as determined by this test method cannot be interpreted as the probable ignition temperature of the same carbon under the operating conditions of a specific application unless those conditions are essentially the same as those in this test method. If it is desired to determine the ignition temperature of the carbon under a specific set of operating conditions, the test may be modified to simulate such conditions, taking into consideration the following variables: (1) air flow rate; (2) moisture content of the carbon; (3) bed depth; ( 4) relative humidity of the air stream; (5) heating rate; (6) contaminants (for example, hydrocarbons, etc.) in the air

            
下载：
         
         

十月有个革命

请问活性炭纤维的测试方法也同样适用吗？