BS EN 62271-110-2009 高压开关和控制设备.第110部分:电感负载开关

sigh007

                   【英文标准名称】:     High-voltage switchgear and controlgear - Part 110:Inductive load switching            【原文标准名称】:     高压开关和控制设备.第110部分:电感负载开关            【标准号】:     BS EN 62271-110-2009            【标准状态】:     现行            【国别】:     英国            【发布日期】:     2009-07-31    【实施或试行日期】: 2009-07-31【发布单位】: 英国标准学会(GB-BSI)【起草单位】: BSI【标准类型】: ()【标准水平】: ()【中文主题词】: 交流开关和控制开关;交流电流;断路器;电路;尺寸选定;电气工程;电气设备;电气安全性;电磁兼容性(EMC);高电压;高压电器;高压开关装置;高压开关设备;电感;感应式调压器;感应;绝缘;室外电站;特性;防电击;合格试验;额定电压;额定值;常规检验;开关设备;测试;变压器;【英文主题词】: AC switchgear and controlgear;Alternating current;Circuit-breakers;Circuits;Dimensioning;Electrical engineering;Electrical equipment;Electrical safety;EMC;High voltage;High-voltage equipment;High-voltage switchgear;High-voltage switchgears;Induction;Induction-voltage regulators;Inductive;Insulations;Outdoor stationsropertiesrotection against electric shocks;Qualification tests;Rated voltages;Ratings;Routine check tests;Switchgears;Testing;Transformers;【摘要】: This International Standard is applicable to a.c. circuit-breakers designed for indoor or outdoor installation, for operation at frequencies of 50 Hz and 60 Hz on systems having voltages above 1000 V and applied for inductive current switching with or without additional short-circuit current breaking duties. The standard is applicable to circuit-breakers in accordance with IEC 62271-100 that are used to switch high-voltage motor currents and shuntreactor currents and also to high-voltage contactors used to switch high-voltage motor currents [2]. Switching unloaded transformers, i.e. breaking transformer magnetizing current, is not considered in this standard. The reasons for this are as follows:a) due to the non-linearity of the transformer core, it is not possible to correctly model the switching of transformer magnetizing current using linear components in a test laboratory.Tests conducted using an available transformer, such as a test transformer, will only be valid for the transformer tested and cannot be representative for other transformers;b) as detailed in CIGRE Technical Brochure 305 [1], the characteristics of this duty are usually less severe than any other inductive current switching duty. It should be noted that such a duty may produce severe overvoltages within the transformer winding(s) depending on the circuit-breaker re-ignition behaviour and transformer winding resonancefrequencies.Short-line faults, out-of-phase current making and breaking and capacitive current switching are not applicable to circuit-breakers applied to switch shunt reactors or motors. These duties are therefore not included in this standard.Subclause 1.1 of IEC 62271-100 is otherwise applicable.【中国标准分类号】: K43【国际标准分类号】: 29_130_10【页数】: 32P.;A4【正文语种】: 英语