BS EN 50131-3-2009 报警系统.侵入和拦截系统.控制和指示设备

sigh007

                   【英文标准名称】:     Alarm systems. Intrusion and hold-up systems. Control and indicating equipment            【原文标准名称】:     报警系统.侵入和拦截系统.控制和指示设备            【标准号】:     BS EN 50131-3-2009            【标准状态】:     现行            【国别】:     英国            【发布日期】:     2009-04-30    【实施或试行日期】: 2009-04-30【发布单位】: 英国标准学会(GB-BSI)【起草单位】: BSI【标准类型】: ()【标准水平】: ()【中文主题词】: 报警系统;防偷窃措施;建筑物;防盗警报;交付使用;定义;探测器;检波器(回路);电气工程;供能系统(建筑物);环境条件;环境试验;拦截报警系统;检验;侵入探测器;作标记;信息中心;性能试验;设备;设备结构;性能;可靠性;保护技术;安全性装置;安全性工程;安全性要求;规范(验收);监督(认可);体系建筑;试验;测试条件;偷窃;警报系统【英文主题词】: Alarm systems;Anti-burglar measures;Buildings;Burglar alarms;Commissioning;Definitions;Detector;Detectors (circuits);Electrical engineering;Energy supply systems (buildings);Environmental conditions;Environmental testing;Hold-up alarm systems;Inspection;Intrusion detectors;Marking;Message centreerformance testslantlant constructionroperties;Reliability;Safeguarding techniques;Safety devices;Safety engineering;Safety requirements;Specification (approval);Surveillance (approval);System building;Testing;Testing conditions;Theft;Warning system【摘要】: This standard specifies the requirements, performance criteria and testing procedures for control andindicating equipment (CIE) intended for use in intrusion and hold-up alarm systems (I&HAS) installedin buildings. This document also applies to CIE to be used in IAS or HAS.The CIE may incorporate processing functions of other I&HAS components or its processingrequirements may be distributed among such components.This standard specifies the requirements for CIE installed in buildings using specific or non-specificwired interconnections or wire-free interconnections. These requirements also apply to ACE that areinstalled inside or outside of the supervised premises and mounted in indoor or outdoor environments.Where CIE shares means of detection, interconnection, control, communication, processing and/orpower supplies with other applications, these requirements apply to I&HAS functions only.This standard specifies performance requirements for CIE at each of the four security grades identifiedin the European Standard EN 50131-1, “Alarm Systems – Intrusion and hold-up systems – Systemrequirements”. Requirements are also specified for four environmental classes covering applicationsfor indoor and outdoor locations.This standard includes mandatory functions, which shall be provided on all CIE for the appropriatesecurity grade, as well as optional functions that may additionally be provided.This standard does not deal with requirements for compliance with EU regulatory Directives, such asthe EMC Directive, Low Voltage Directive, etc. except in that it specifies the equipment operatingconditions for EMC susceptibility testing as required by EN 50130-4.NOTE In this standard reference to the term “I&HAS” is used throughout, except where there is specific need to differentiatebetween the IAS and HAS portions of a system. The term is intended to include IAS and HAS when such systems are installedseparately.【中国标准分类号】: A91【国际标准分类号】: 13_310【页数】: 78P.;A4【正文语种】: 英语