BS EN 10343-2009 建筑用淬火和回火钢.技术交货条件

sigh007

                   【英文标准名称】:     Steels for quenching and tempering for construction purposes - Technical delivery conditions            【原文标准名称】:     建筑用淬火和回火钢.技术交货条件            【标准号】:     BS EN 10343-2009            【标准状态】:     现行            【国别】:     英国            【发布日期】:     2009-04-30    【实施或试行日期】: 2009-04-30【发布单位】: 英国标准学会(GB-BSI)【起草单位】: BSI【标准类型】: ()【标准水平】: ()【中文主题词】: 验收规范;化学成分;一致性评估;建筑;定义;交货条件;名称与符号;尺寸;扁钢;锻件;硬化和冷拔;热处理钢;高强度钢;热轧的;检验;制造过程;机械性能;性能;薄板材;规范(验收);规范;试样制备;钢棒;钢的等级;钢产品;钢;材料强度;窄条带材;试验;宽扁材【英文主题词】: Acceptance specification;Chemical composition;Conformity assessment;Construction;Definitions;Delivery conditions;Designations;Dimensions;Flat steels;Forgings;Hardened and drawn;Heat-treatable steels;High-tensile steels;Hot rolled;Inspection;Manufacturing process;Mechanical propertiesroperties;Sheet materials;Specification (approval);Specifications;Specimen preparation;Steel bars;Steel grades;Steel products;Steels;Strength of materials;Tape;Testing;Wide flats【摘要】: This document specifies the technical delivery requirements for the following steel products intended for use inthe construction industry:bars (including hammer-forged bars);wide flats;hot-rolled strip and sheet/plate;forgings.They are manufactured from the direct hardening non alloy steels for quenching and tempering and the directhardening alloy steels for quenching and tempering and supplied in one of the heat treatment conditions givenfor the different types of products in Table 1.These steels are generally intended for the manufacture of quenched and tempered parts, but can also beused in the normalized condition.The requirements for mechanical properties are restricted to part sizes given in Tables 4 and 5.NOTE 1 In accordance with EN 10020, the steels covered by this standard are quality and special steels. Thedifferences between quality and special steels are characterized by the following requirements, which are valid for specialsteels only:? the minimum impact values in the quenched and tempered condition (for non alloy special steels in the case of meanpercentages by mass of carbon < 0,50 % only);? limited oxide inclusion content;? lower maximum contents for phosphorus and sulphur.NOTE 2 This standard does not apply for bright steel products.NOTE 3 This standard only applies for the manufacture of products without any further cold or hot forming and noadditional heat treatment, i.e. the properties are according to the delivery condition (+N, +QT).In addition to the specifications of this European Standard, the general technical delivery conditions given inEN 10021 will be applicable unless otherwise specified.【中国标准分类号】: H40【国际标准分类号】: 77_140_10【页数】: 38P.;A4【正文语种】: 英语