【英文标准名称】: Practice for use of thermoluminescence dosimetry (TLD) systems for radiation processing 【原文标准名称】: 辐射加工用热致发光剂量测定(TLD)系统使用规程 【标准号】: ISO/ASTM 51956-2005 【标准状态】: 现行 【国别】: 国际 【发布日期】: 2005-05 【实施或试行日期】: 【发布单位】: 国际标准化组织(ISO)【起草单位】: ISO/TC 85【标准类型】: ()【标准水平】: ()【中文主题词】: 热致发光剂量;电离辐射;辐射测量;剂量测定;核辐射;γ辐射;辐射剂量;选择;校正;X射线;定义【英文主题词】: thermoluminescence dosimetry;definitions;calibration;ionizing radiation;nuclear radiation;radiation measurement;dosimetry;selection;gamma-radiation;definition;x-rays;radiation dose【摘要】: 1 This practice covers procedures for the use of thermolu-minescence dosimeters (TLDs) to determine the absorbed dose in materials irradiated by photons or electrons in terms of absorbed dose to water.2 This practice covers systems that permit absorbed dose measurements under the following conditions:2.1 The absorbed-dose range is from 1 Gy to 100 kGy.2.2 The absorbed-dose rate is between 1 × 10 and 1 × 10 Gy s.2.3 The radiation-energy range for photons and electrons is from 0.1 to 50 MeV.3 Absorbed dose and absorbed-dose rate measurements in materials subjected to neutron irradiation are not covered in this practice.4 Procedures for the use of TLDs for determining ab-sorbed dose in radiation-hardness testing of electronic devices are given in ASTM Practice E 668.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appro-priate safety and health practices and determine the applica-bility of regulatory limitations prior to use.【中国标准分类号】: F80【国际标准分类号】: 17_240【页数】: 8P;A4【正文语种】: 英语