标题: ISO 14590-2005 高抗拉强度、低屈服点、增强成型性冷轧薄钢板 [打印本页] 作者: sigh007 时间: 2012-3-22 18:10:08 标题: ISO 14590-2005 高抗拉强度、低屈服点、增强成型性冷轧薄钢板
【英文标准名称】: Cold-reduced steel sheet of high tensile strength and low yield point with improved formability 【原文标准名称】: 高抗拉强度、低屈服点、增强成型性冷轧薄钢板 【标准号】: ISO 14590-2005 【标准状态】: 现行 【国别】: 国际 【发布日期】: 2005-02 【实施或试行日期】: 【发布单位】: 国际标准化组织(ISO)【起草单位】: ISO/TC 17【标准类型】: ()【标准水平】: ()【中文主题词】: 抗拉强度;试验;可加工性;形状公差;冷轧的;定义;扁平轧材;尺寸公差;扁钢;屈服强度;钢产品;钢;化学成分;机械性能【英文主题词】: Chemical composition;Cold rolled;Definition;Definitions;Dimensional tolerances;Flat rolled products;Flat steels;Form tolerances;Mechanical properties;Steel products;Steels;Tensile strength;Testing;Workability;Yield strength【摘要】: 1.1 This International Standard applies to killed cold-reduced steel sheet of two types that are commerciallyavailable in the world. Type 1 (Table 1) represents steels that are produced to mechanical properties only andType 2 (Table 2) are produced to both mechanical and chemical properties. Bake hardening steels areincluded in both types. All these steels are commonly produced by continuous annealing.1.2 Cold-reduced sheet less than 600 mm wide may be slit from wide sheet and will be considered as sheet.1.3 This International Standard does not cover steels designated as commercial quality or drawing qualities(covered in ISO 3574), steels of structural quality (covered in ISO 4997) or steels of higher strength withimproved formability (covered in ISO 13887).【中国标准分类号】: H46【国际标准分类号】: 77_140_50【页数】: 13P;A4【正文语种】: 英语