世界资料网论坛

标题: ASTM D3756-1997(2010) 用辐散场评定固体介质材料抗树枝状电下载 [打印本页]

作者: sigh007 时间: 2013-1-26 17:01:04 标题: ASTM D3756-1997(2010) 用辐散场评定固体介质材料抗树枝状电下载

本帖最后由 infoeach 于 2013-2-18 15:35 编辑

中文名称: 用辐散场评定固体介质材料抗树枝状电击穿性的试验方法

英文名称:Standard Test Method for Evaluation of Resistance to Electrical Breakdown by Treeing in Solid Dielectric Materials Using Diverging Fields

中标分类：K15	ICS分类：29.035.01
标准分类编号：AS	页数：6

发布日期：	实施日期：1997-09-10	作废日期：
被替代标准：		代替标准：ASTM D3756-1997(2004)
引用标准：ASTM D149;ASTM D1711;ASTM D1928;ASTM D2275;ANSI/IEEE930-1987		采用标准：
起草单位：		归口单位：

标引依据：

补充修订：

备注：

范围：1.1 This test method covers the evaluation and comparison of the resistance of solid organic dielectric materials to the initiation or growth, or both, of tubular tree-like channels resulting from partial discharge (corona) and molecular decomposition that occur in the region of very high, diverging electric fields. , 1.2 This test method is primarily for use at a power frequency of 50 or 60 Hz. 1.3 The test may be carried out at room temperature or temperatures above or below room temperature. The temperature should not exceed the softening or melting point of the sample material. 1.4 This test method can be used for any solid material into which needles can be cast, molded, or inserted with heat after molding. The resistance to tree initiation is measured by the double-needle characteristic voltage, which is only applicable to non-opaque materials so that tree can be observed optically. The resistance to tree initiation and growth is reported by the double-needle voltage lif

下载：[attach]78[/attach]

作者: 2013 时间: 2013-3-17 00:00:11

谢谢楼主分享！！！！！！！！！！！！！！！！！

作者: a280221580 时间: 2014-11-9 15:55:59

谢谢分享

作者: flowerwin 时间: 2016-4-25 10:45:22

很需要谢谢楼主，需要研究这个标准

欢迎光临世界资料网论坛 (http://bbs.infoeach.com/)