世界资料网论坛

标题: ANSI/ASTM F1924-2005 外径可控的聚乙烯供气管道用塑料机械配件规范 [打印本页]

作者: sigh007 时间: 2012-3-22 16:14:29 标题: ANSI/ASTM F1924-2005 外径可控的聚乙烯供气管道用塑料机械配件规范

【英文标准名称】: Specification for Plastic Mechanical Fittings for Use on Outside Diameter Controlled Polyethylene Gas Distribution Pipe and Tubing 【原文标准名称】: 外径可控的聚乙烯供气管道用塑料机械配件规范【标准号】: ANSI/ASTM F1924-2005 【标准状态】: 现行【国别】: 美国【发布日期】: 2005-08-01 【实施或试行日期】: 【发布单位】: 美国国家标准学会(ANSI)【起草单位】: ASTM【标准类型】: ()【标准水平】: ()【中文主题词】: 质量要求;燃气管;试验方法;聚氯乙烯;塑料;配件【英文主题词】: Fittings;Gas pipes;Gases

lastics

olyvinyl chloride;Quality requirements;Rotation tests;Test methods【摘要】: This specification describes requirements and test methods for the qualification of plastic bodied mechanical fittings for use with outside diameter controlled polyethylene (PE) gas distribution pipe, nominal 2 pipe size (IPS) and smaller complying with Specification D 2513. In addition, it specifies general requirements of the material from which these fittings are made. The test methods described in this specification are not intended to be used as routine quality control tests. This specification covers the types of mechanical fittings described in . The values stated in inch-pound units are to be regarded as the standard. The values given in parentheses are for information only. The following safety hazards caveat pertains only to the test method portion, Section 7, of this specification. This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. The text of this specification references notes and footnotes, which provide explanatory material. These notes and footnotes (excluding those in tables and figures) shall not be considered as requirements of this specification.【中国标准分类号】: G95【国际标准分类号】: 23_040_45【页数】: 【正文语种】: 英语

欢迎光临世界资料网论坛 (http://bbs.infoeach.com/)