【英文标准名称】: Standard Test Method for Measuring the Damage Resistance of a Fiber-Reinforced Polymer-Matrix Composite to a Concentrated Quasi-Static Indentation Force 【原文标准名称】: 测量聚合物基复合材料集中准静态压痕损伤的标准试验方法 【标准号】: ASTM D6264/D6264M-2007 【标准状态】: 现行 【国别】: 美国 【发布日期】: 2007 【实施或试行日期】: 【发布单位】: 美国材料与试验协会(US-ASTM)【起草单位】: D30.05【标准类型】: (Test Method)【标准水平】: ()【中文主题词】: 【英文主题词】: composite materials; damage resistance; delamination; dent; impact; quasi-static indentation【摘要】: 1.1 This test method determines the damage resistance of multidirectional polymer matrix composite laminated plates subjected to a concentrated indentation force (Fig. 1). Procedures are specified for determining the damage resistance for a test specimen supported over a circular opening and for a rigidly-backed test specimen. The composite material forms are limited to continuous-fiber reinforced polymer matrix composites, with the range of acceptable test laminates and thicknesses defined in 8.2. This test method may prove useful for other types and classes of composite materials.1.2 A flat, square composite plate is subjected to an out-of-plane, concentrated force by slowly pressing a hemispherical indenter into the surface. The damage resistance is quantified in terms of a critical contact force to cause a specific size and type of damage in the specimen.1.3 The test method may be used to screen materials for damage resistance, or to inflict damage into a specimen for subsequent damage tolerance testing. The indented plate can be subsequently tested in accordance with Test Method D 7137/D 7137M to measure residual strength properties. Drop-weight impact per Test Method D 7136/D 7136M may be used as an alternate method of creating damage from an out-of-plane force and measuring damage resistance properties.1.4 The damage resistance properties generated by this test method are highly dependent upon several factors, which include specimen geometry, layup, indenter geometry, force, and boundary conditions. Thus, results are generally not scalable to other configurations, and are particular to the combination of geometric and physical conditions tested.1.5 The values stated in either SI units or inch-pound units are to be regarded separately as standard. Within the text the inch-pound units are shown in brackets. The values stated in each system are not exact equivalents; therefore, each system must be used independently of the other. Combining values from the two systems may result in nonconformance with the standard.1.6 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.【中国标准分类号】: G31【国际标准分类号】: 83_12【页数】: 11P.;A4【正文语种】: 英语 作者: liuxilin1215 时间: 2015-1-9 20:41:52