ASTM D7396-2014 制备新和连续的镀锌(电镀)钢材表面用于喷漆
本帖最后由 free2_citiz 于 2018-5-15 13:42 编辑ASTM D7396-2014 制备新和连续的镀锌(电镀)钢材表面用于喷漆的标准指南
ASTM D7396-2014 制备新和连续的镀锌(电镀)钢材表面用于喷漆的标准指南
Standard Guide for Preparation of New, Continuous Zinc-Coated (Galvanized) Steel Surfaces for Painting
标准号
ASTM D7396-2014
发布日期
2014
实施日期
废止日期
无
中国标准分类号
G51
国际标准分类号
25.220.20 (Surface treatment)
发布单位
US-ASTM
适用范围
This guide describes procedures that can be used to prepare new zinc-coated surfaces for painting and improve the bond of paint to the zinc surface.
1.1 This guide covers surface cleaning and various methods of treating new zinc-coated by the continuous process (galvanized) surfaces produced by either the hot-dip method or by electroplating. This guide covers surfaces that have not been treated previously at the mill to provide temporary protection against staining by moisture other than by easily removed protective oils (see Appendix X1). For preparing surfaces of new or weathered items of zinc-coated steel produced by batch processing, refer to Practice D 6386.
1.2 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
谢谢您的分享，金币已奖励!
页:
[1]