SAE AS 8879D-2004 螺纹 -UNJ牙形,牙底圆弧半径加大并受控的米制
本帖最后由 86858748 于 2016-8-28 08:54 编辑SAE AS 8879D-2004 螺纹 -UNJ牙形,牙底圆弧半径加大并受控的米制螺纹
英文版
Screw Threads - UNJ Profile, Inch Controlled Radius Root with Increased Minor Diameter [Superseded: OASD MIL-S-8879 C CANC NOTICE 3, OASD MIL-S-8879 C NOTICE 2, OASD MIL-S-8879 C NOTICE 1, OASD MIL-S-8879 C (1), OASD MIL-S-8879 C, OASD MIL-S-008879
This SAE Aerospace Standard (AS) specifies the characteristics of screw threads - UNJ profile inch series, including a mandatory controlled radius as specified in Table 1 at the root of the external thread. The minor diameter of both external and internal threads provides a basic thread height of .5625H to accommodate the external thread maximum root radius. The following detailed design requirements are included: a. Screw threads - UNJ basic profile and design profiles. b. Standard series of diameter-pitch combinations for nominal thread diameters from 0.060 to 6.000 inches. c. Standard thread classes and form tolerances. d. Formulae for thread dimensions and tolerances. e. Method of designating UNJ threads. f. Tables for selected diameter-pitch combinations for close tolerance mechanical thread applications. g. Tables for screw thread - UNJ profile thread limit dimensions. This document specifies the geometric design for each characteristic of screw threads - UNJ profile inch series and the conformance requirements. In addition, the purpose of this standard is to: a. Define the geometric requirements for a selected series of Unified Screw Threads, modified to provide a radius at the external thread root. b. Establish requirements for a continuous radius at the root of the external threads. c. Establish requirements for an increase in the minor diameter of both internal and external threads to accommodate the external thread root radius.
谢谢您的分享，金币已奖励!
页:
[1]